Textiles can be used in formaldehyde, PH value, azo content testing and other supporting equipment, can be sample into uniform small cubes, greatly improving the sample preparation efficiency.

Formaldehyde is an important index to measure the safety performance of textiles.Accurate detection of formaldehyde content in textiles is the premise to maintain consumer safety.

PH is a measure of PH, 7 is neutral;Less than 7 is acidic;Anything greater than 7 minus 14 is basic.The National standard GB18401-2003 National Technical Specification for Basic Safety of Textile Products makes clear and strict requirements on the PH value of textile products, stipulating that the PH value of Category B in direct contact with skin should be 4.0-7.5 and that of category C in non-direct contact with skin should be 4.0-9.0.If the PH value is too high or too low, it should be neutralized with corresponding acid and base until it reaches the standard, otherwise it will harm the health of the contacts.

Knife die of various specifications

(With DM series cutting die, samples of different sizes and sizes can be prepared)

Scope of Application:

Laboratory textile and garment, rubber, plastic, leather, toys, paper testing and sample preparation field, can prepare physical energy, chemical items test samples.

[Crushing textile tester instrument characteristics] :

1. Two working modes are suitable for different sample making needs.

2. Combined pressure of gas and oil cylinders, quiet and noiseless.

3. Multiple safety protection: two-hand button switch;Infrared induction;Tool die installation status prompt;Prompt for template installation status;Screen soft switch.

4. Separate external air compressor or external centralized air supply device.

5. Pressure speed and time can be adjusted to meet the needs of different samples.

6. With DM series knife die, samples of different sizes and sizes can be prepared.

7. Special cleaning air gun can prevent cross contamination of samples.

8. Initial Angle and rotation Angle can be set.

[Technical parameters] :

1. Diameter of pressure plate: 20×20cm.

Pressure: 4kg/cm.

3. Sample size: According to different test requirements, samples of different sizes and sizes can be made with the cutter mold. The minimum sample size is 5mm×5mm.

4. Sample preparation efficiency: a complete sample preparation process: about 20 seconds;Sample weight: according to sample material and die.When 5mm×5mm textile samples are produced, about 20g can be produced at one time, which can meet the requirements of formaldehyde, pH value, prohibited azo, composition quantification, agricultural residues and other testing items.

5. The maximum working pressure is 10 tons, and the working air source pressure is not less than 0.5mpa.

6. External dimension: 500×400×1200mm.

7. Weight: 200kg.

8. Adjustable rotation Angle: 30°-180°.

Email: hello@utstesters.com

Direct: + 86 152 6060 5085

Tel: +86-596-7686689

Web: www.utstesters.com