Working principle: 

Constant temperature and humidity box is a special experimental equipment, it can fine-tune the internal environmental parameters (such as temperature, humidity, wind speed, air pressure, etc.) to keep it in a certain range. The constant temperature and humidity box uses a variety of sensors to monitor the internal environmental parameters, and these parameters are processed by the microprocessor, and then adjust the internal environmental parameters according to the needs.

Features: 

1. The internal environmental parameters can be adjusted according to different experimental requirements. 

2. The internal environment parameters can be accurate within a certain period of time. 

3. Advanced sensors are used to monitor the internal environmental parameters. 

4. The internal environment parameters can be quickly adjusted according to different circumstances. 

5. Easy to operate and easy to use.

Application range of constant temperature and humidity environment simulation tester: 

1. Electronic products, electrical components, mechanical parts, materials and packaging materials in high and low temperature, high and low humidity environment performance test; 

2. Preservation performance test of medical products, food and other substances in high and low temperature, high and low humidity environment; 

3. Preservation performance test of agricultural products in high and low temperature, high and low humidity environment; 

4. Durability test of vehicle parts and internal equipment in high and low temperature and high and low humidity boxes; 

5. Indoor or outdoor durability testing of flight and space equipment.

More details

1. Calibration: Install the sample to be tested together with the sensor into the box, and then open the switch on the sample to be tested. Install the sample in the box with the sensor, and then turn on the switch on the sample. 

2. Adjust parameters: Analyze the data collected by the sensor on the test sample, and adjust parameters according to the target to be achieved. 

3. Running time: After the sample to be tested and the sensor are installed into the box and the parameters are calibrated, the running time can start. 

4. Maintenance at the end of detection: When the experimental time expires or certain conditions are monitored, the power supply shall be turned off immediately and the samples to be tested shall be repaired.

Email: hello@utstesters.com

Direct: + 86 152 6060 5085

Tel: +86-596-7686689

Web: www.utstesters.com